|
Posted
Friday, May 30th 12:20am [Edit] [Quote] [IMS] [View car] |
Post nr. 1565
|
A couple of fan blades broke in the motor installation......how hard is it to replace the plastic fan blades? Will I need to take off the radiator? |
 |
|
|
Posted
Friday, May 30th 12:34am [Edit] [Quote] [IMS] [View car] |
Post nr. 276
|
Easy. - A pain, but easy. 20 min tops
No, radiator can stay on
It is one reverse threaded 32mm bolt that hold the fan on in the center. This removes the fan and the fan clutch at the same time.
You need a Thin 32mm spanner wrench for removing Fan Clutch
Bav Auto sells one for $34.95 which fits perfect. But a bit pricy. -It is a really tight fit though so make sure you get a thin long wrench,,,,,,
They also sell another expensive too for holding the fan in place. if you hit the wrench with a hammer though you can make it budge pretty easy without this tool.
I changed the fan clutch a while back like 4 times,,,,,,,, |
|
|
|
Posted
Friday, May 30th 11:07am [Edit] [Quote] [IMS] [View car] |
Post nr. 1566
|
The clutch is fine. I just need to replace the blades. Can I leave the fan clutch in by taking out those 4 to 5 bolts from the back? |
|
|
|
Posted
Friday, May 30th 6:16pm [Edit] [Quote] [IMS] [View car] |
Post nr. 277
|
I wouldnt recomend it man,
if you can make it work great!}
I think its much easier to take off the whole unit and then take off the fan, really it only takes 20min if you have the wrench. If you dont mind taking off the radiator that would probably give you enough space to leave on the whole unit and just remove the fan, but i dont rememeber from which direction the bolts thread in.
luck |
|
|
|
Posted
Saturday, May 31st 2:17pm [Edit] [Quote] [IMS] [View car] |
Post nr. 1173
|
Go to a bicycle shop for the thin 32 wrench. $12. |
|
|
|
Posted
Sunday, Jun 1st 1:34am [Edit] [Quote] [IMS] [View car] |
Post nr. 279
|
good call! those are thin as hell...id completely forgotten about those, try to get a park one if you can |
|
|
